Network
administrators can install SNMP (Simple Network Management
Protocol) software on network computers so they can monitor
projectors. If your network uses this software, you can set up the
projector for SNMP monitoring.
Press
the Menu button.
Select
the Network menu and press
Enter.
Select
Network Configuration and press
Enter.
Do one
of the following:
Select the
Others menu and press Enter.
Select the
Administrator Setting menu and press
Enter, then select the SNMP menu and press Enter.
PowerLite Pro G6800/G6900WU
PowerLite Pro
G6050W/G6150/G6450WU/G6550WU/G6750WU
Select
the SNMP menu and press Enter(PowerLite
G6050W/G6150/G6450WU/G6550WU/G6750WU).
Enter up
to two IP addresses to receive SNMP notifications, using 0 to 255
for each address field.
Note:To
enter the IP address using the numeric keys on the remote control,
press and hold the Num
button. Do not use these addresses: 127.x.x.x or 224.0.0.0
through 255.255.255.255 (where x is a number from 0 to
255).
If your
network environment uses an AMX controller, turn on the
AMX Device Discovery setting to
allow the projector to be detected (PowerLite Pro
G6800/G6900WU).
If your
network environment uses a Crestron RoomView controller, turn on
the Crestron RoomView setting to
allow the projector to be detected (PowerLite Pro
G6800/G6900WU).
If you
are connecting to a network using Bonjour, turn on the Bonjour setting (PowerLite Pro
G6800/G6900WU).
If you
want this projector to receive broadcasted messages over the
network, turn on the Message
Broadcasting setting. Administrators can broadcast messages
over the network using the Message Broadcasting plug-in for EasyMP
Monitor (PowerLite Pro G6800/G6900WU) (Windows
only).
When you
finish selecting settings, select Complete or Setup
complete and follow the on-screen instructions to save your
settings and exit the menus.