Before you
can project from computers on your network, you must select the
network settings for the projector using its menu system.
Note: Make sure
you already connected the projector to your wired network using the
LAN port.
Turn on
the projector.
Press
the Menu button.
Select
the Network menu and press
Enter.
Select
Network Configuration and press
Enter.
Select
the Basic menu and press
Enter.
Select
the following basic options as necessary:
Projector Name lets you enter a name up to 16
alphanumeric characters long to identify the projector over the
network.
Web Remote Password(PowerLite Pro
G6050W/G6150/G6450WU/G6550WU/G6750WU) or Web Control Password(PowerLite Pro
G6800/G6900WU) lets you enter a password up to 8
alphanumeric characters long for accessing the projector over the
web. (Default user name is EPSONWEB;
default password is admin.)
Projector Keyword(PowerLite Pro
G6050W/G6150/G6450WU/G6550WU/G6750WU) lets you turn on a
security password to prevent access to the projector by anyone not
in the room with it. You must enter a displayed, randomized keyword
from a computer using the EasyMP Network Projection software to
access the projector.
Note: Use the
displayed keyboard to enter the name, passwords and keyword. Press
the arrow buttons on the remote control to highlight characters and
press Enter to select
them.
Select
the Wired LAN menu and press
Enter.
Select
your IP Settings as necessary:
If your
network assigns addresses automatically, turn on the DHCP setting.
If you must
set addresses manually, turn off DHCP and enter the projector's IP Address, Subnet
Mask, and Gateway Address as
needed.
Note: To highlight
the numbers you want from the displayed keyboard, press the arrow
buttons on the remote control. To select a highlighted number,
press Enter.
To
prevent display of the IP address on the standby screen, turn off
IP Address Display.
When you
finish selecting settings, select Setup
complete and follow the on-screen instructions to save your
settings and exit the menus.