administrators can install SNMP (Simple Network Management
Protocol) software on network computers so they can monitor
projectors. If your network uses this software, you can set up the
projector for SNMP monitoring.
the Menu button.
the Network menu and press
Network Configuration and press
Select the Others menu
and press Enter.
to two IP addresses to receive SNMP notifications, using 0 to 255
for each address field.
enter the IP address using the numeric keys on the remote control,
press and hold the Num
button. Do not use these addresses: 127.x.x.x or 184.108.40.206
through 255.255.255.255 (where x is a number from 0 to
are connecting to a network using Bonjour, turn on the Bonjour setting.
want this projector to receive broadcasted messages over the
network, turn on the Message
Broadcasting setting. Administrators can broadcast messages
over the network using the Message Broadcasting plug-in for EasyMP
Monitor (Windows only).
finish selecting settings, select Complete and follow the on-screen instructions
to save your settings and exit the menus.