Setting Up Your Product with Wi-Fi Auto Connect

Your product broadcasts its network information for 60 minutes from the time ink charging begins. If you run the product's software setup package within this 60 minute period, the software automatically connects the product to your wireless network without you having to enter your network name (SSID) and password.

If it has been longer than 60 minutes since the product was first charged with ink, see the section on setting up your product using a temporary USB connection instead.

Note: If your computer does not have a CD/DVD drive or you are using a Mac, an Internet connection is required to obtain the product software.
  1. Make sure your product is turned on but NOT CONNECTED to your computer with a USB cable.
    Note: With Windows, if you see a Found New Hardware screen, click Cancel and disconnect the USB cable.
  2. Insert the product CD or download your product’s software package from global.latin.epson.com/Support/L375.
  3. Select your language and click Next (Windows), or click Continue and click Continue again (OS X).
  4. Accept the software license agreement to continue with software installation.
  5. When you see one of these screens, click Install.

    Windows



    OS X



    Note: With OS X, make sure you install Software Updater to receive firmware and software updates for your product.
    Software installation may take several minutes. Wait for the installation to complete.
  6. OS X: If you see the following message, click Yes or No to continue.


  7. When the Printer Setup screen appears, click Next (Windows) or Start (OS X) to begin setting up your product on your network.


  8. When you see this screen, select Wireless connection and click Next (Windows) or Continue (OS X).


  9. When you see this screen, select Set up printer for the first time and click Next (Windows) or Continue (OS X).


  10. When you see this screen, select Yes and click Next (Windows) or Continue (OS X).


    You see a screen like this:


  11. Click Next to continue.
    Note: If you see a firewall alert message, click Unblock or Allow to let EpsonNet Setup continue. Do not select Ask Me Later, Keep Blocking, or Block.
  12. OS X: If you see the following messages, click OK and click Allow to let EpsonNet Setup access your password information.




  13. Follow the on-screen instructions to let the system automatically configure your product on your network.
    Note: If the software cannot automatically configure your product to the network, you may be prompted to enter your network name (SSID) and password on a displayed screen. You can also select a different Wi-Fi setup method.
  14. OS X: When you see this screen, click Add Printer and follow the on-screen instructions to add your product and the print queue to your system. Then click Continue.


    Note: Be sure to select your Epson product in the Use or Print Using drop-down list.
  15. When you see this screen, print a test page and click Next (Windows) or Continue (OS X).


  16. Windows: The system begins searching for the latest firmware for your product. If you see this screen, new firmware is available. Click Next and follow the on-screen instructions. When you are ready, click Start and wait for the firmware update to finish.


    IMPORTANT: DO NOT TURN OFF YOUR PRODUCT OR INTERRUPT THE FIRMWARE SEARCH PROCESS IN ANY WAY.
  17. Follow the on-screen instructions to complete product setup. When you see this screen, click Exit (Windows) or Close (OS X) to close the installation program.


Parent topic: Setting Up Your Product on a Wireless Network
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use