| Light status | Condition/solution |
|---|---|
The  power light is on |
The printer is turned on. |
| The power light is flashing |
The printer is busy. Wait for the
power light to stop flashing
before turning off the printer. |
| The Ethernet light is lit | The printer is connected to the network. |
The  maintenance box light is
on |
The maintenance box is at the end of its
service life or not installed. Press the  black cleaning and
 color cleaning buttons at the
same time to clear the error, then install or replace the
maintenance box. |
| The maintenance box light is
flashing |
The maintenance box is near the end of its service life. Make sure you have a replacement maintenance box. |
The  paper light is on |
Paper may be out. Load more paper in the
cassette or rear MP tray and press the paper feed button to
continue. |
| If multiple sheets have fed, press the
paper feed button to eject
the paper. |
|
| The paper size selected may not match any of
the sizes set for the paper sources. Press the paper feed button to clear
the error, and select the right paper size. |
|
| If the paper cassette is not installed,
install it and press the paper feed button.
Unsupported paper size fed during 2-sided printing. Press the
|
|
| The paper light is flashing |
Paper has jammed in the printer. Check in the
cassette, inside the printer, and in the duplexer to remove the
jammed paper. Then press the paper feed button to clear
the error. |
| The paper light is flashing
fast |
Not enough memory in the printer to continue
printing. Press the paper feed button to cancel
the current job. |
| The power and paper light are flashing |
The front cover is open. Close the cover. |
| An ink out light is on |
An ink cartridge is expended or not installed correctly. Replace the indicated cartridge. Make sure the cartridge is installed correctly. |
| An ink out light is
flashing |
An ink cartridge is low. Make sure you have a replacement cartridge. |
| All lights are flashing | Printer error. Check in the cassette, inside the printer, and in the duplexer to remove the jammed paper. Turn the printer off and then back on again. If the error does not clear, contact Epson. |
| The yellow ink out light is
flashing |
The firmware update has failed, and the printer is in recovery mode. Visit Epson's support website at www.epson.com/support (U.S.) or www.epson.ca/support (Canada) for instructions on repeating the firmware update. |
cancel