If you cannot print over a network, try these solutions:
- Make sure
that your product is turned on.
- Make sure
you install your product's network software as described in your
product documentation.
- Print a
network status sheet and verify that the network settings are
correct. If the network status is Disconnected, check any cable connections and
turn your product off and then on again.
- If you are
using TCP/IP, make sure the product's IP address is set correctly
for your network. If your network does not assign IP addresses
using DHCP, set the IP address manually.
- Make sure
your computer and product are both using the same wireless
network.
- If network
printing is slow, print a network status sheet and check the signal
strength. If it is poor, place your product closer to your router
or access point.
Note: Avoid
placing your product near a microwave oven, 2.4 GHz cordless phone,
or large metal object, such as a filing cabinet.
- If you are
connecting the product via EpsonNet Setup and the WiFi
light on your product is not solid green (WorkForce Pro
WP-4533), make sure your product software was installed
correctly. If necessary, reinstall your software.