You
need to clean the projector's air filter in the following
situations:
The filter
or vents get dusty.
You see a
message telling you to clean it.
The
projector's filter light flashes green.
Turn off the projector and unplug the power cord.
Slide the air filter cover latch and open the air
filter cover.
Pull the air filter out of the projector.
Tap each side of the air filter 4 to 5 times to shake off any
excess dust.
Caution:
Do not use excessive force when tapping the
air filter, or it may crack and become unusable. Do not rinse the
air filter in water, or use any detergent or solvent to clean it.
Do not use canned air; the gases may leave a residue, or push dust
and debris into the projector's optics or other sensitive
areas.
Vacuum the front of the air filter (the side with the tabs)
to remove any remaining dust.
Note: If dust is
difficult to remove or the air filter is damaged, replace the air
filter.
Place the air filter back in the projector as shown and
push gently until it clicks into place.