Loading Paper in Cassette 1 (Upper Cassette)

You can load photo paper and other media in these sizes in the upper paper cassette:
Note: Do not remove or insert the paper cassette during printing.
  1. Close the output tray, if necessary.


    Note: As you slide in the output tray, there may be slight resistance and noise. This is normal.
  2. Open the front cover.


  3. Pull out the upper paper cassette. The upper cassette has a label on the right side.


    Note: If the cassette is too far inside the product to reach, turn the product off and then back on again to reset the cassette's position.
  4. Slide the edge guides outward.


  5. Set the front edge guide to the position for the paper size you are using.


    Note: Various paper sizes are marked on the tray.
  6. Insert paper with the glossy or printable side facedown.


    Note: Make sure the paper is loaded against the front edge guide.
  7. Slide the side edge guides against the paper, but not too tightly.


    Note: Make sure the paper is under the tabs on the edge guides.
  8. Keep the cassette flat as you insert it until the left and right arrow marks on the tray and product line up.


    Note: Leave enough space in front of the product for the paper to be fully ejected. Do not remove or insert the paper cassette while the product is operating.
Always follow these paper loading guidelines:
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use