If a WirelessHD source does not display correctly,
try the following solutions:
- Make sure WirelessHD is selected as the image source on the
projector.
-
Open the
WirelessHD reception monitor in the Settings menu and check the
strength of the WirelessHD signal. If the signal is weak, you may
need to move the transmitter closer to the projector or remove any
large objects located between the transmitter and the
projector.
- Make sure that your projector is connected to the correct
WirelessHD device. It can take up to 30 seconds for a signal to
sync and appear after connecting.
- You may need to reset the WirelessHD connection. Turn off both
the WirelessHD transmitter and the projector. Start playback on
your video device, then turn on the WirelessHD transmitter and the
projector. Wait 10 seconds, then press the Setup button on the bottom of the
transmitter.
- Make sure the WirelessHD transmitter is within 32 feet (10 m)
of the projector, isn’t obstructed by any large objects, and is not
placed on a metal surface.
- If the green and orange lights on the transmitter are flashing,
the unit may be overheating. Make sure the vents on the back of the
transmitter are not blocked and that the room temperature does not
exceed 95 °F (35 °C).
- If you are viewing wireless content, make sure that the WiHD
light on the transmitter is on. If it is off, press the
Output button on the remote control
or transmitter.