Finger touch
calibration coordinates the positioning of your finger with the
location of the cursor (BrightLink 595Wi).
Note: Make sure
you have calibrated the pens before calibrating for finger touch
interactivity.
Press
the Menu button, select the
Extended menu, and press
Enter.
Select
the Easy Interactive Function
setting and press Enter.
Select
Touch Unit Setup and press
Enter.
Select
Touch Calibration and press
Enter.
The following screen appears:
Adjust
the image focus, if necessary.
Press
Enter to select Yes. A flashing green circle appears in
the upper left corner of your projected image.
Touch
and hold the center of the circle with your finger until the circle
disappears and another circle appears, then release it. The
circle disappears, and you see another circle below the first one.
Note: For the most
accurate calibration, make sure you touch the center of the circle
with the tip of your finger.
Note: Make sure
you are not blocking the signal between your finger and the
interactive receiver (next to the projection window on the
projector).
Touch
the center of the next circle with your finger and continue until
all of the circles disappear. When you get to the bottom of
a column, the next circle appears at the top of a new column.
Note: If you make
a mistake, press the Esc button on
the remote control to go back to the previous circle. To restart
the calibration process, press and hold the Esc button for 2 seconds.
If the
cursor location and your finger position do not match, repeat these
steps to calibrate again.