can project from computers on your network, you must select the
network settings for the projector using its menu system.
Note: Make sure
you already connected the projector to your wired network using the
the Menu button.
the Network menu and press
Network Configuration and press
the Basic menu and press
the following basic options as necessary:
Projector Name lets you enter a name up to 16
alphanumeric characters long to identify the projector over the
PJLink Password lets you enter a password up to
32 alphanumeric characters long for using the PJLink protocol for
Web Control Password lets you enter a password
up to 8 alphanumeric characters long for accessing the projector
over the web. (Default user name is EPSONWEB; default password is admin.)
Projector Keyword lets you turn on a security
password to prevent access to the projector by anyone not in the
room with it. You must enter a displayed, randomized keyword from a
computer using the EasyMP Network Projection software to access the
Note: Use the
displayed keyboard to enter the name, passwords and keyword. Press
the arrow buttons on the remote control to highlight characters and
press Enter to select
the Wired LAN menu and press
necessary, select IP Settings and
your IP Settings as necessary:
network assigns addresses automatically, turn on the DHCP setting.
If you must
set addresses manually, turn off DHCP and enter the projector's IP Address, Subnet
Mask, and Gateway Address as
Note: To highlight
the numbers you want from the displayed keyboard, press the arrow
buttons on the remote control. To select a highlighted number,
press Enter. Or, press and
hold the Num button on the remote
control while entering the desired numbers.
prevent display of the IP address on the standby screen, turn off
IP Address Display.
finish selecting settings, select Complete and follow the on-screen instructions
to save your settings and exit the menus.