Accessing Web Config

You can access Web Config from your browser using HTTP or HTTPS.

By default, you access Web Config for the first time using HTTP. If you continue to use HTTP, Web Config does not display all available menus.

  1. Print a network status sheet for your product and identify the product IP address. See the product's User's Guide for instructions.
  2. Start your web browser and make sure JavaScript is enabled.
  3. Type the product IP address into the browser as follows, depending on the protocol you are using:
    • IPv4: http://product IP address
    • IPv6: http://[product IP address]/
    The Basic Settings page appears:


  4. To use HTTPS, configure the address to use HTTPS in your browser. A message warning about the self-signed certificate appears.
To access Web Config after configuring the address to use HTTPS, enter https:// before the product IP address, shown in step 3.
Note: If the product name is registered with the DNS server, you can use the product name instead of the product IP address to access Web Config.
Parent topic: Using Web Config Network Configuration Software