The
remote control's ID is set to zero by default so it can operate any
compatible projector. If you want to set the remote control to
operate only a particular projector, you need to set the remote
control's ID to match the projector's ID.
Turn on the projector you want the remote control to operate
with exclusively.
Make sure you know the projector's ID number as set in the
Extended menu Projector ID
setting.
Aim the remote control at that projector.
Hold down the ID button on the
remote control while you press the numeric button that matches the
projector's ID. Then release the buttons.
Press the ID button on the
remote control to check if the ID-setting process worked.
You see a message displayed by the projector.
If the
remote control is listed as On, the
remote control ID is set to operate only the listed projector.
If the
remote control is listed as Off, the
remote control ID is not set properly. Repeat the steps above to
set the ID to match the projector you want to control.
Note: You must set
the remote control ID to match the projector ID each time you turn
on the projector you have set it to control.