Cleaning the Print Head Using the Product Control Panel

You can clean the print head nozzles using the control panel on your product.
  1. Make sure the CD/DVD tray is not inserted for printing.
  2. Load a few sheets of plain paper in the product.
  3. Press the  home button, if necessary.
  4. Press the arrow buttons to select Setup and press the OK button.
  5. Select Maintenance and press the OK button.


  6. Select Head Cleaning and press the OK button.


  7. Press the  start button to clean the print head. You see a message on the LCD screen during the cleaning cycle.
    Caution:
    Never turn off the product during a cleaning cycle or you may damage it.
    When the cleaning cycle is finished, you see a message on the display screen.
  8. Select Print nozzle check pattern and press the OK button. Press  start to run a nozzle check and confirm that the print head is clean.
If you don’t see any improvement after cleaning the print head up to 2 times, turn off the product and wait at least 6 hours. Then try cleaning the print head again. If quality still does not improve, one of the ink cartridges may be old or damaged and needs to be replaced.
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use