If you cannot print over a network, try these
that your product is turned on.
you install your product's network software as described in your
network status sheet and verify that the network settings are
correct. If the network status is Disconnected, check any cable connections and
turn your product off and then on again.
If you are
using TCP/IP, make sure the product's IP address is set correctly
for your network. If your network does not assign IP addresses
using DHCP, set the IP address manually.
your computer and product are both using the same wireless
printing is slow, print a network status sheet and check the signal
strength. If it is poor, place your product closer to your router
or access point. Avoid placing your product near a microwave oven,
2.4 GHz cordless phone, or large metal object, such as a filing
Note: If you
are using a 5 GHz wireless router, set the router to operate in
dual band (2.4 GHz and 5 GHz) mode. See your router documentation
Check to see
if your wireless router or access point has an enabled Privacy
Separator function that is preventing printing from a device over
the network. See your router or access point documentation for
instructions on disabling the Privacy Separator function.
If you are
connecting the product wirelessly via EpsonNet Setup and the Wi-Fi
connection icon is not lit or does not appear on the product's LCD
screen, make sure your product software was installed correctly. If
necessary, reinstall your software.