Make sure
you have your replacement ink packs handy before you begin. You
must install new ink packs immediately after removing the old
ones.
If an ink pack is low or expended, a message appears on
your product and on your computer screen. Note which ink packs need
to be replaced.
Open the ink case.
Note: The
illustrations in this section show the black ink pack, but the
procedure is the same for the color ink packs on the other side of
the product.
Press the handle on the ink pack you are replacing.
The ink pack pops out.
Lift up the ink pack and remove it from the ink
case.
Warning: If
ink gets on your skin, wash it thoroughly with soap and water. If
ink gets into your eyes, flush them immediately with water. If ink
gets into your mouth, spit it out and see a doctor right away. Keep
ink packs out of the reach of children.
Unpack the new ink pack
Remove any protective materials, and do not touch the
green chip on the handle area.
Shake the ink pack horizontally 20 times as shown.
Caution:
Do not remove any labels or seals, or ink
will leak.
Place the ink pack in the case. Make sure the bottom of
the ink pack fits over the base as shown.
Place the ink pack handle on the holder as shown.
Press in the handle until it clicks into place.
Select Check on the LCD
screen to make sure the ink packs are installed
correctly.