Follow these safety instructions when setting up and
using the projector:
look into the lens when the projector is on. The bright light can
damage your eyes. Avoid standing in front of the projector so the
bright light does not shine into your eyes.
place the projector on an unstable cart, stand, or table.
operate the projector on its side, or while tilted to one side.
Do not tilt the projector more than 30° forward
projector is mounted on a ceiling or wall, it should be installed
by qualified technicians using mounting hardware designed for use
with this projector.
installing or adjusting a ceiling or wall mount, do not use
adhesives to prevent the screws from loosening and do not use oils
or lubricants. This may cause the projector case to crack and the
projector to fall from its ceiling mount. This could cause serious
injury to anyone under the mount and could damage the
Do not use
the projector near water, sources of heat, high-voltage electrical
wires, or sources of magnetic fields.
type of power source indicated on the projector. Use of a different
power source may result in fire or electric shock. If you are not
sure of the power available, consult your dealer or power
projector near a wall outlet where the plug can be easily
following precautions when handling the plug: Do not hold the plug
with wet hands. Do not insert the plug into a dusty outlet. Insert
the plug firmly into the outlet. Do not pull the power cord when
disconnecting the plug; always be sure to hold the plug when
disconnecting it. Do not overload wall outlets, extension cords, or
power strips. Failure to comply with these precautions could result
in fire or electric shock.
place the projector where the cord can be walked on. This may
result in fraying or damage to the plug.
projector from the wall outlet and allow to cool before cleaning.
Use a dry cloth (or, for stubborn dirt or stains, a moist cloth
that has been wrung dry) for cleaning. Do not use liquid or aerosol
cleaners, any sprays containing flammable gas, or solvents such as
alcohol, paint thinner, or benzine.
block the slots and openings in the projector case. They provide
ventilation and prevent the projector from overheating. Do not
operate the projector on a sofa, rug, or other soft surface, or set
it on top of loose papers. Do not cover the projector with a
blanket, curtain, or tablecloth. If you are setting up the
projector near a wall, leave at least 7.9 inches (20 cm) of space
between the wall and the projector.
operate the projector in a closed-in cabinet unless proper
ventilation is provided.
allow objects of any kind to enter any openings in the projector.
Do not leave objects, especially flammable objects, near the
projector. Never spill liquid of any kind into the projector.
If you are
using two or more projectors side-by-side, leave at least 2
feet (60 cm) of space between the projectors to allow for
need to clean the air filter and vent. A clogged air filter or vent
can block ventilation needed to cool the projector. Do not use
canned air, or the gases may leave a residue.
store the projector outdoors for an extended length of time.
specifically explained in this manual, do not attempt to service
this product yourself. Refer all servicing to qualified personnel.
Opening or removing covers may expose you to dangerous voltages and
any covers on the projector except as specifically explained in
this manual. Never attempt to disassemble or modify the projector.
Refer all repairs to qualified service personnel.
projector from the wall outlet and refer servicing to qualified
service personnel under the following conditions: if it does not
operate normally when you follow the operating instructions, or
exhibits a distinct change in performance; if smoke, strange odors,
or strange noises come from the projector; if the power cord or
plug is damaged or frayed; if liquid or foreign objects get inside
the projector, or if it has been exposed to rain or water; if it
has been dropped or the housing has been damaged.
touch the plug during an electrical storm. Otherwise, you may
receive an electric shock.
projector when it will not be used for extended periods.
Do not use
the projector where it may be exposed to rain, water, or excessive
Do not use
or store the projector where it may be exposed to smoke, steam,
corrosive gases, excessive dust, vibration, or shock.
Do not use
the projector where flammable or explosive gases may be
Do not use
or store the projector or remote control in a hot location, such as
near a heater, in direct sunlight, or in a closed vehicle.
If you use
the projector in a country other than where you purchased it, use
the correct power cord for that country.
stand on the projector or place heavy objects on it.
Do not use
the projector outside of the required temperature range of 41
to 95 °F (5 to 35 °C) at an altitude of 7500 feet (2286 m) or less,
or 41 to 86 °F (5 to 30 °C) at a higher altitude. Doing so
may cause an unstable display and could lead to projector damage.
Do not use or store the projector where it may be exposed to sudden
changes in temperature.
store the projector outside of the required temperature range of 14
to 140 °F (–10 to 60 °C) or in direct sunlight for long periods of
time. Doing so may cause damage to the case.
place anything that can become warped or damaged by heat near the
exhaust vents. Do not bring your hands or face close to the vents
while projection is in progress. Do not bring your face close to
the projector while it is in use.
move the projector, make sure its power is turned off, the plug is
disconnected from the outlet, and all cables are disconnected.
to remove the lamp immediately after use because it will be
extremely hot. Before removing the lamp, turn off the power and
wait at least an hour to allow the lamp to cool completely.
disassemble the lamp or subject it to impacts.
place the source of an open flame, such as a lit candle, on or near
block the lens during projection using a book or any object other
than the lens cover. This could damage the projector or cause a
modify the power cord. Do not place heavy objects on top of the
power cord or bend, twist, or pull it excessively. Keep the power
cord away from hot electrical appliances.
lamp breaks, ventilate the room to prevent gases contained in the
lamp from being inhaled or coming in contact with your eyes or
mouth. If you do inhale gases or gases come in contact with your
eyes or mouth, seek medical advice immediately.
projector is mounted overhead and the lamp breaks, be careful to
prevent pieces of glass from falling into your eyes or mouth when
you open the lamp cover. If pieces of glass do get into your eyes
or mouth, seek medical advice immediately.
lower the volume before turning off the projector. Turning on the
projector with the volume too high can damage your ears.
WARNING: The cords included with
this product contain chemicals, including lead, known to the State
of California to cause birth defects or other reproductive harm.
Wash hands after handling.
(This notice is provided in accordance with Proposition 65 in Cal.
Health & Safety Code § 25249.5 and following.)