Printer error. Turn the power off and on again. For
details, see your documentation. |
A fatal error has occurred. Turn the product off and
then back on again. If the error continues, check for a paper jam.
If there is no paper jam, contact Epson for support. |
Operation canceled. An error occurred while
saving. |
The memory card or external device may be damaged.
Check the device and replace it if necessary. |
Ink is low. |
Ink in a cartridge is low. You can continue printing
or replace the cartridge. |
You need to replace the following ink
cartridge(s). |
Replace the ink cartridge indicated on the LCD
screen. |
Paper Configuration is disabled. Some features may not
be available. For details, see your documentation. |
If Paper Configuration is disabled, you cannot use
AirPrint. Also, you will not see warnings about paper size or type
mismatches. Keep Paper Configuration enabled unless you always use
the same size and type of paper. |
Communication error. Check if a computer is
connected. |
Make sure the computer is connected to your product
and your software is installed correctly. |
A printer's ink pad is nearing the end of its service
life. Please contact Epson Support. |
The ink pads are near the end of their service life
and the message will be displayed until the ink pad is replaced.
Contact Epson for support. (To resume printing, press the
Start button.) |
A printer's ink pad is at the end of its service life.
Please contact Epson Support. |
The ink pad is at the end of its service life. Turn
off the product and contact Epson for support. |
Combination of IP address and subnet mask is invalid.
See your documentation. |
There is a problem with the network connection to your
product. Check the solutions in this guide. |
Recovery mode |
An error has occurred during firmware updating.
Connect your product using a USB cable and try updating the
firmware again. If you still receive this error message, contact
Epson for support. |