Use the
front manual feed tray to load media with a thickness of 0.047 to
0.059 inch (1.2 to 1.5 mm).
Note: Be sure to
leave at least 17 inches (43 cm) of space behind your product for
the media to feed through.
Turn on
your product.
Remove
any paper from the sheet feeder and close the paper
support.
Remove
any roll paper and the roll paper unit, if necessary.
Close
the rear paper support.
Press
the front cover to open it.
Press
the center of the manual feed tray and release it to extend the
tray.
Insert a
single sheet of posterboard or thick media into the manual feed
tray. Insert it short edge first with the printable side up.
Note: Never try to
load media from the rear or you could damage your
product.
Feed the
paper up to the line on the tray. Make sure the paper is flush
against the right side, then pull the paper back gently to align it
against the edge of the manual feed tray.
Select
Load on the touch screen. The paper
loads into your product.
Note: If you
return to the home screen, select Load
Guide and follow the instructions on the touch
screen.
When you
see a message on the screen, close the manual feed tray by pushing
it in until it latches.
Fully
extend the output tray.
If
necessary, select the Paper Size and
Paper Type, then press OK.
To eject
paper, select Eject on the touch
screen and select Yes to
confirm.
Caution:
Do not extend the manual feed tray during
printing, or you may damage your product.