Cleaning the Print Head Using the Product Control Panel

You can clean the print head using the control panel on your product.
  1. Load a few sheets of plain paper in the product.
  2. Press the  home button, if necessary.
  3. Press the left or right arrow button to select Setup and press the OK button.
  4. Press the up or down arrow button to select Maintenance and press the OK button. You see this screen:


  5. Press the up or down arrow button to select Head Cleaning and press the OK button. You see this screen:


  6. Press the  start button to begin the cleaning cycle.
    Caution:
    Never turn off the product during a cleaning cycle or you may damage it.
    The  power light flashes throughout the cleaning cycle and stays on green when the cleaning cycle is finished. You see this screen:


  7. Select Nozzle Check and press the OK button to run a nozzle check to confirm that the print head is clean.
If you don’t see any improvement after cleaning the print head up to 4 times, turn off the product and wait at least 6 hours. Then try cleaning the print head again. If quality still does not improve, one of the ink cartridges may be old or damaged and needs to be replaced.
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use