Loading Posterboard and Thick Media

Use the front manual feed tray to load media with a thickness of 0.028 to 0.051 inch (0.7 to 1.3 mm).
Caution:
Do not open the front manual feed tray or load thick paper while the product is operating. This may damage your product.
Note: Be sure to leave at least 13 inches (32 cm) of space behind your product for the media to feed through.
  1. Turn on your product.
  2. Remove any paper from the sheet feeder and close the paper support.
  3. Remove any roll paper and the roll paper holders.
  4. Open the front cover.

  5. Open the front manual feed tray.


  6. Slide the edge guide all the way to the left.


  7. Insert a single sheet of posterboard or thick media into the manual feed tray, short edge first and printable side up.


    Caution:
    Never load media from the rear or you could damage your product.
  8. Feed the paper up to the triangles near the end of the tray. Make sure the paper is flush against the right side and slide the edge guide to the edge of the paper.


Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use