You can display information about the projector and input sources by viewing the Info menu. However, you cannot change any settings in the menu.
Select Version to display the projector's firmware version. Select Projector Info to display the settings described below.
Note: Available
settings depend on the current input source. The lamp usage timer
does not register any hours until you have used the lamp for at
least 10 hours.
| Information item | Description |
|---|---|
| Lamp Hours | Displays the number of hours (H) the lamp has been used in Normal and ECO Power Consumption modes; if the information is displayed in yellow, obtain a genuine Epson replacement lamp soon |
| Source | Displays the name of the port to which the current input source is connected |
| Input Signal | Displays the input signal setting of the current input source |
| Resolution | Displays the resolution of the current input source |
| Scan Mode | Displays the scan mode of the current input source |
| Refresh Rate | Displays the refresh rate of the current input source |
| 3D Format | Displays the 3D format of the current input source during 3D projection |
| Sync Info | Displays information that may be needed by a service technician |
| Deep Color | Displays the deep color of the current input source |
| Status | Displays information about projector problems that may be needed by a service technician |
| Serial Number | Displays the projector's serial number |
| Event ID (PowerLite 2045) | Displays the Event ID number corresponding to a specific projector problem; see the list of Event ID codes |