You
need to clean the projector's air filter in the following
situations:
The filter
or vents get dusty.
You see a
message telling you to clean it.
The
projector's filter light flashes green.
Turn off the projector, wait for the projector
to beep, and unplug the power cord.
Slide the air filter cover
latch and open the air filter cover.
Pull the air filter out of the
projector.
Tap each side of the air filter 4 to 5 times
to shake off any excess dust. Do this outside the
room or away from the projector.
Caution:
Do not use excessive force when tapping
the air filter, or it may crack and become unusable. Do not rinse
the air filter in water, or use any detergent or solvent to clean
it. Do not use canned air; the gases may leave a residue, or push
dust and debris into the projector's optics or other sensitive
areas.
Vacuum the front of the air filter (the side
with the tabs) to remove any remaining dust.
Note: If dust
is difficult to remove or the air filter is damaged, replace the
air filter.
Place the air filter back in
the projector as shown and push gently until it clicks into
place.