You
can select projector commands you want to perform and schedule them
as an event.
Press the Menu button.
Select the Extended menu and press Enter.
Select the Schedule Settings setting and press
Enter. The Schedule
Settings screen appears.
Select the Schedule menu and press Enter.
Select Add
New and press Enter.
In the Event Settings section, select the
events you want to have occur. (Select No Change for events that you do not want to
occur.)
Note: You
cannot schedule an event to occur at the following times: five
minutes before or after a Color Calibration event, or five minutes
before or 30 minutes after a Screen Matching event. Light Source
Calibration events do not start if the projector is used
continuously for more than 24 hours, or regularly turned off by
shutting off the power outlet. Set Light
Source Calibration events to occur only after 100 hours of
usage.
In the Date/Time Settings section, set the
date and time for the scheduled events to occur.
When you are finished, select Save and press Enter.
To schedule more events, repeat the previous
steps as necessary.
Select Setup
complete and select Yes to
save your changes.