If a WirelessHD source does not display correctly,
try the following solutions:
- Make sure WirelessHD is selected as the image source
on the projector.
- Open the
WirelessHD reception monitor in the Settings menu and check the
strength of the WirelessHD signal. If the signal is weak, you may
need to move the transmitter closer to the projector or remove any
large objects located between the transmitter and the
projector.
- Make sure that your projector is connected to the
correct WirelessHD device. It can take up to 30 seconds for a
signal to sync and appear after connecting.
- You may need to reset the WirelessHD connection.
Turn off both the WirelessHD transmitter and the projector. Start
playback on your video device, then turn on the WirelessHD
transmitter and the projector. Wait 10 seconds, then press the
Setup button on the bottom of the
transmitter.
- Make sure the WirelessHD transmitter is within 32
feet (10 m) of the projector, isn’t obstructed by any large
objects, and is not placed on a metal surface.
- If you are viewing wireless content, make sure that
the WiHD light on the transmitter is on. If it is off, press the
WiHD/Pass
button on the remote control or transmitter.
- Make sure the HDMI cable between the source and the
WirelessHD transmitter conforms to HDMI standards.