Enabling Protocol Emulation

You can use protocol emulation to control your projector with the same RS-232 control codes as those used by the manufacturers of other projectors. This lets you control a group of projectors from a common controller.
  1. Make sure the projector is turned on.
  2. Connect a controller to the RS-232C port on the projector.
  3. Do one of the following:
    • Press and hold the Test Pattern button on the remote control for at least five seconds.
    • Select the Extended menu, highlight the Standby Mode setting, and hold down the right arrow button on the remote control or projector control panel for at least five seconds.
    You see the Protocol Emulation screen.
  4. Select one of the following and press Enter:
    • Type P for Panasonic projectors
    • Type M for Mitsubishi projectors
    • Type N for NEC projectors
    • Type S for Sony projectors
  5. Turn the projector off and on again to enable the control code you selected.
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use