Replacing the Air Filters

You need to replace the air filters in the following situations:

You can replace an air filter while the projector is mounted to the ceiling or placed on a table.

Note: The projector has one air filter on the front and two on the sides. The illustrations here show replacing the air filter on the front, but the steps are the same to replace the filters on the side.


  1. Turn off the projector, wait for the projector to beep, and unplug the power cord.
  2. Loosen the screw securing the air filter cover.


  3. Open the air filter cover.


  4. Pull the air filter out of the projector.


    Note: Air filters contain polypropylene. Dispose of used air filters according to local regulations.
  5. Place the new air filter in the projector as shown and push gently until it clicks into place.


  6. Close the air filter cover.


  7. Tighten the screw securing the air filter cover.


  8. Repeat these steps to replace the other air filters.
    Note: The air filter cover on the side of the projector is attached to a cord to prevent it from falling.


Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use