Setting Up Monitoring Using SNMP

Network administrators can install SNMP (Simple Network Management Protocol) software on network computers so they can monitor projectors. If your network uses this software, you can set up the projector for SNMP monitoring.
  1. Press the Menu button.
  2. Select the Network menu and press Enter.
  3. Select Network Configuration and press Enter.
  4. Select the Notifications menu and press Enter.

  5. Turn on the SNMP setting.
  6. Enter up to two IP addresses to receive SNMP notifications as the Trap IP Address setting, using 0 to 255 for each address field.
    Note: To enter the IP address using the numeric keys on the remote control, press and hold the Num button. Do not use these addresses: 127.x.x.x or through (where x is a number from 0 to 255).
  7. Select the Others menu and press Enter.

  8. If you want to use the Secure HTTP protocol to encrypt communication when using Web Control, turn on the Secure HTTP setting and import the web server certificate using the Web Server Cert. setting.
  9. If available, select the Priority Gateway setting for your network.
  10. If your network environment uses an AMX controller, turn on the AMX Device Discovery setting to allow the projector to be detected.
  11. If your network environment uses a Crestron RoomView controller, turn on the Crestron RoomView setting to allow the projector to be detected.
  12. If you are using the projector with a Control 4 Simple Device Discovery Protocol (SDDP) automation system, turn on the Control4 SDDP setting.
  13. If you want this projector to receive broadcast messages over the network, turn on the Message Broadcasting setting. Administrators can broadcast messages over the network using the Message Broadcasting plug-in for EasyMP Monitor (Windows only).
  14. When you finish selecting settings, select Complete and follow the on-screen instructions to save your settings and exit the menus.
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use