The
remote control's ID is set to zero by default so it can operate any
compatible projector. If you want to set the remote control to
operate only a particular projector, you need to set the remote
control's ID to match the projector's ID.
- Turn on the projector you want the remote control to operate with exclusively.
-
Make sure you know the projector's ID number
as set in the Extended menu Projector
ID setting.
Note: If you have forgotten the projector's ID, aim the remote control at the projector and press the ID button to temporarily display the projector's ID on the screen.
- Aim the remote control at that projector.
- Hold down the ID button on the remote control while you press the numeric button that matches the projector's ID. Then release the buttons.
-
Press the ID
button on the remote control to check if the ID-setting process
worked. You see a message displayed by the projector.
- If the remote control is listed as On, the remote control ID is set to operate only the listed projector.
- If the remote control is listed as Off, the remote control ID is not set properly. Repeat the steps above to set the ID to match the projector you want to control.
Note:
- You must set the remote control ID to match the projector ID each time you turn on the projector you have set it to control.
- When you select 0 on the remote control, you can operate all projectors regardless of the Projector ID setting.
- If you turn off the Projector ID setting, the remote control will operate the projector regardless of the ID selected on the remote.
