Network
administrators can install SNMP (Simple Network Management
Protocol) software on network computers so they can monitor
projectors. If your network uses this software, you can set up the
projector for SNMP monitoring.
Press the Menu
button.
Select the Network menu
and press Enter.
Select Network
Configuration and press Enter.
Select the Notifications menu and press Enter.
Turn on the SNMP setting.
Enter up to two IP addresses to receive SNMP
notifications, using 0 to 255 for each address field.
Note: To
enter the IP address using the numeric keys on the remote control,
press and hold the Num button. Do
not use these addresses: 127.x.x.x or 224.0.0.0 through
255.255.255.255 (where x is a number from 0 to 255).
Select the Others menu and press Enter.
If available, select the Priority Gateway setting for your
network.
If your network environment uses an AMX controller, turn
on the AMX Device Discovery
setting to allow the projector to be detected.
If your network environment uses a Crestron RoomView
controller, turn on the Crestron
RoomView setting to allow the projector to be
detected.
If you are using the projector with a Control 4 Simple
Device Discovery Protocol (SDDP) automation system, turn on the
Control4 SDDP
setting.
If you want this projector to receive broadcast messages
over the network, turn on the Message
Broadcasting setting. Administrators can broadcast messages
over the network using the Message Broadcasting plug-in for EasyMP
Monitor (Windows only).
When you finish selecting settings, select Complete and follow the on-screen
instructions to save your settings and exit the menus.