Solutions When Only a Partial Image Appears

If only a partial computer image appears, try the following solutions:
  • Make sure the Resolution setting in the Signal menu is set correctly to for the input signal.
  • Try adjusting the image position using the Position menu setting.
  • Press the Aspect button on the remote control to select a different image aspect ratio.
  • If you zoomed into or out of the image using the E-Zoom buttons, press the Esc button until the projector returns to a full display.
  • Check your computer display settings to disable dual display and set the resolution within the projector's limits. (See your computer manual for details.)
  • Check the resolution assigned to your presentation files to see if they are created for a different resolution than you are projecting in. (See your software help for details.)
  • Make sure you selected the correct Projection setting.
  • Try adjusting the image position using the Image Shift setting.
  • If you are passing the video signal through another device, make sure the device is set up correctly, then try connecting the video source directly to the projector.
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use