If a
password is set up and a Power On Protection password is
enabled, you see a prompt to enter a password whenever you turn on
the projector.
You must enter the correct password to use the
projector.
Press and hold down the Num button on the remote control while you
enter the password using the numeric buttons.
Note: The
default password is 0000.
The password screen closes.
If the password is incorrect, the following
may happen:
You
see a "wrong password" message and a prompt to try again. Enter the
correct password to proceed.
If you enter an incorrect password three
times in succession, you see a message telling you that the
projector is locked. After the message is displayed for 5 minutes,
the projector enters standby mode. Unplug the projector, plug in
the power cord, and turn on the projector. You see a prompt to
enter the password.
If you continue to enter an incorrect
password many times in succession, the projector displays a request
code and a message to contact Epson Support. Do not attempt to
enter the password again. When you contact Epson Support, provide
the displayed request code and proof of ownership for assistance in
unlocking the projector.