Checking the Nozzles Using the Product Control Panel

You can check the print head nozzles using the control panel on your product.
  1. Load a few sheets of plain paper in the product.
  2. Press the  home button, if necessary.
  3. Press the left or right arrow button to select Setup and press the OK button.
  4. Press the up or down arrow button to select Maintenance and press the OK button. You see this screen:


  5. Press the OK button.
  6. Press the  start button. After the nozzle pattern prints, you see this screen:


  7. Check the printed pattern to see if there are gaps in the lines.

    Print head is clean



    Print head needs cleaning



  8. Do one of the following:
    • If there are no gaps, select Finish Nozzle Check and press the OK button.
    • If there are gaps or the pattern is faint, select Head Cleaning and press the OK button to continue.
  9. Follow the instructions on the screen to clean the print head, check the nozzles, and repeat the process as necessary.
If you don’t see any improvement after cleaning the print head up to 4 times, turn off the product and wait at least 6 hours. Then try cleaning the print head again. If quality still does not improve, one of the ink cartridges may be old or damaged and needs to be replaced.
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use