You can
load a photo or large, thick, or folded original in the input tray
using one or more carrier sheets. You can also load envelopes. Make
sure the originals meet the specifications for special originals
before loading them.
Open the input tray and pull up its
extension.
Pull out the output tray and its
extension, and open the stopper.
Note: If you are
loading originals that are 15.5 inches (393.8 mm) or longer, do not
pull out the input or output tray extensions and do not open the
stopper.
Slide the input tray edge guides all
the way out.
Load envelopes vertically in the input
tray with the printable side down and the flap facing as shown.
Slide in the envelopes until they meet resistance.
Do one
of the following to load a photo, or folded or irregularly shaped
originals:
For a Letter- or A4-size or larger original, fold it as shown
and place it in the center of an optional carrier sheet. Make sure
the illustration on the front edge of the carrier sheet is facing
up.
For a photo or an irregularly shaped original, load it in the
center of an optional carrier sheet with the printed side face
down. Make sure the illustration on the front edge of the carrier
sheet is facing up.
Load the carrier sheet in the input
tray as shown until it meets resistance.
Folded original
Photo or irregularly shaped
original
Slide
the edge guides against the edges of the original or carrier
sheet.
Turn off the Detect Double Feed setting on the Main Settings
tab in Epson Scan 2 when scanning special originals.
If necessary during scanning, adjust
the position of the stopper on the output tray extension to fit the
ejected originals.
Note: If thicker
paper does not eject properly or falls from the output tray, push
in the output tray and allow the originals to eject freely onto the
surface below the scanner. If the scanned images are affected by
the originals ejecting below the scanner, try placing the scanner
on the edge of a table where the ejected originals can drop
freely.