You can use
protocol emulation to control your projector with the same RS-232
control codes as those used by the manufacturers of other
projectors. This lets you control a group of projectors from a
common controller.
Make sure the projector is turned on.
Connect a controller to the RS-232C port on the
projector.
Do one of the following:
Press and
hold the Test Pattern button on
the remote control for at least five seconds.
Select the
Extended menu, highlight the
Standby Mode setting, and hold
down the right arrow button on the remote control or projector
control panel for at least five seconds.
You see the Protocol Emulation screen.
Select one of the following and press Enter:
Type P for Panasonic projectors
Type M for Mitsubishi projectors
Type N for NEC projectors
Type S for Sony projectors
Turn the projector off and on again to enable the protocol
emulation you selected.