Using WPS to Connect to a Network

If you have a WPS-enabled router or access point, you can use Wi-Fi Protected Setup (WPS) to connect your device to the network.

Note: To check if your router is WPS-enabled, look for a button labeled WPS on your router or access point. If there is no hardware button, there may be a virtual WPS button in the software for the device. Check your network product documentation for details.

To connect to a WPS-enabled router, press the WPS button on your router or access point.
Press and hold down the Wi-Fi button on your product for 3 seconds. The Wi-Fi and Wi-Fi Direct lights flash alternately. When the Wi-Fi light stays on, the connection is successful.
Note: Be sure to press and hold the Wi-Fi button on your product within 2 minutes of pressing the WPS button on your router or access point.

If the

Wi-Fi and

Wi-Fi Direct lights flash simultaneously, there is a connection error. Press the Wi-Fi button, restart your router, move it closer to your product, and repeat the steps here to try again.