Loading Paper or Envelopes in the Rear Paper Feed Slot

You can print envelopes or documents in a variety of paper types and sizes in the rear paper feed slot.
  1. Open the feeder guard and pull up the paper support.


  2. Slide the edge guides outward.


  3. If you are inserting a stack of paper, fan the sheets and tap the stack on a flat surface to even the edges.
    Note: You can load one sheet of binder paper with holes on one of the long edges as shown. Do not select automatic 2-sided printing for this type of paper.


  4. Do one of the following:
    • Insert paper, glossy or printable side up and short edge first, in the center of the slot.


      Caution:
      To prevent paper feeding problems, make sure you do not load paper above the arrow marks inside the edge guides.
    • Load envelopes short edge first, with the flap facing down and the flap edge to the left, in the center of the slot.


  5. Slide the edge guides against the paper or envelopes, but not too tightly.


  6. Extend the output tray.


  7. Do one of the following:
    • Select the size and type of paper you loaded on the LCD screen.
    • Press the  Paper Setting button and select the paper source, then select the size and type of paper you loaded.
    • Select the size and type of paper you loaded in the Settings > General Settings > Printer Settings > Paper Source Settings > Paper Setup menu.
Always follow these paper loading guidelines:
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use