Cannot Scan Over a Network

If you cannot start Epson FastFoto when scanning over a network, try these solutions:

• If you cannot scan from the  scan button on the scanner, try restarting your computer. Also start Epson FastFoto before scanning with the  scan button.
• Make sure your scanner is correctly paired to Wi-Fi. In Epson FastFoto, go to Settings > Scanner Settings > Change, and make sure the correct scanner is connected.
• If you are scanning a large original at a high resolution, a network communication error may occur. Try scanning again at a lower resolution.
• If network communication was interrupted while starting Epson FastFoto, exit the program, wait a few seconds, and restart it. If Epson FastFoto cannot restart, turn off your scanner, turn it back on, and try starting Epson FastFoto again.
• Check the network connection setting in the Epson Scan 2 Utility.
• If you see a message that the network product is currently being used by another user, there may be a communication error between the scanner and computer. Restart the scanner.
• You may need to temporarily disable your firewall and any anti-virus software on your wireless router. Then try scanning again. You can also unblock your scanner driver or network address in your firewall or anti-virus software.
• If the Firewall function is active, the scanner may not be discovered by the Epson Scan 2 Utility. Open the Epson Scan 2 Utility, enter the IP address for your scanner, and click Add.