If EpsonNet Setup cannot find your product on a network, try
these solutions:
- Make sure
your product is turned on and connected to your network. Verify
connection using your product control panel.
- Check if
your network name (SSID) contains non-ASCII characters. Your
product cannot display non-ASCII characters.
- Make sure
your product is not connected to a guest network.
- If
necessary, reinstall your product software and try running EpsonNet
Setup again:
- Reset your
product's network settings to their factory defaults.
- Windows only: Uninstall your product
software.
- Initialize
your router following the instructions in your router
documentation.
Note: If you are
reading these instructions online, you will lose your Internet
connection when you initialize your router, so note the next step
before initializing it.
- Download
your product software from the Epson website using the instructions
on the Start Here sheet.
- If you have
replaced your router, reinstall your product software to connect to
the new router.
Note: If you are
using a 5 GHz wireless router, set the router to operate in dual
band (2.4 GHz and 5 GHz) mode. If your router uses a single
network name (SSID) for both the 2.4 GHz and 5 GHz band,
give each band its own network name (SSID) instead, such as Home
Network 2.4 GHz and Home Network 5 GHz. See your router
documentation or contact your internet service provider for
instructions.
- Check to see if your wireless router or access point has an
enabled Privacy Separator function that is preventing detection of
your device over the network. See your router or access point
documentation for instructions on disabling the Privacy Separator
function.