For United States Users
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause interference to radio and television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
- Reorient or
relocate the receiving antenna.
- Increase the
separation between the equipment and receiver.
- Connect the
equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the
dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may
cause undesired operation.
The connection of a non-shielded equipment interface
cable to this equipment will invalidate the FCC Certification or
Declaration of this device and may cause interference levels which
exceed the limits established by the FCC for this equipment. It is
the responsibility of the user to obtain and use a shielded
equipment interface cable with this device. If this equipment has
more than one interface connector, do not leave cables connected to
unused interfaces. Changes or modifications not expressly approved
by the manufacturer could void the user’s authority to operate the
For Canadian Users