Using WPS PIN Mode to Connect to a Network

If you have a WPS-enabled wireless router that supports PIN mode, you can use Wi-Fi Protected Setup (WPS) PIN mode to connect your scanner to the network.
  1. Follow the instructions on the Start Here sheet to install the scanner software on your computer.
  2. Find the WPS PIN number setting in your router's firmware.
  3. Make sure the scanner is turned off and set the  Wi-Fi switch to the  Wi-Fi position.
  4. Press and hold the  Wi-Fi connect button and slide and hold the  power switch for about ten seconds until the ready,  Wi-Fi and  Wi-Fi AP lights flash alternately.


    The scanner enters WPS discovery mode for two minutes.
  5. Use your computer to enter the PIN code 01234565 into the WPS PIN number setting in the router firmware within two minutes.
    Note: If you do not enter the code within 2 minutes, repeat the steps to try again.
    Connection setup starts when the ready light flashes, and the  Wi-Fi and  Wi-Fi AP lights flash alternately. When the ready,  Wi-Fi, and  Wi-Fi AP lights on the scanner stay on, the scanner is connected to the network.
Parent topic: Wi-Fi Protected Setup (WPS)