Configuring Tiling Automatically

If your projectors are on a network and you have identified a master projector, you can configure tiling automatically.
  1. Turn on the projector.
    Note: Make sure nothing is blocking the built-in camera on the front of the projector.
  2. Press the Menu button.
  3. Select the Extended menu and press Enter.
  4. Select Multi-Projection and press Enter. You see this screen:

  5. Select Projector Grouping and press Enter. You see a screen like this:

  6. Press the up or down arrow buttons to highlight a projector and press Enter to place a checkmark next to each projector you want to use for tiling. Then select Set and press Enter.
  7. Select Tiling and press Enter.
  8. Select Tiling again and press Enter.

  9. Select Auto and press Esc.
  10. Select Location Setup and press Enter. The projected images are positioned automatically.
  11. When you see the message to assign projector IDs, select Yes. When setup is complete, you see a screen like this:

    Note: If any of the images are not positioned correctly, set up tiling manually instead.
  12. Select the input signal to display an image.
After performing the steps here, adjust the images for any gaps and differences in color.
Note: Do not change any of the projector names or IP addresses, or the images will not be adjusted automatically.
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use