The power light is on |
The product is turned on. |
The Wi-Fi light is on |
The product is connected to a wireless network. |
The Wi-Fi Direct light is
on |
The product is connected to a device using Wi-Fi
Direct. |
The power light is
flashing |
The product is busy. Wait for the power light to stop
flashing before turning off the product. |
The Wi-Fi and Wi-Fi Direct lights are
flashing |
A Wi-Fi connection error has occurred. Press the
Wi-Fi
button to clear the error and try again. |
The ink light is on |
Initial ink charging or ink refilling may not be
complete. See the Start Here sheet for
instructions on initial ink charging. |
The ink light is flashing |
The product is low on ink or the maintenance box is
nearing the end of its service life. If a message to continue
printing appears on your computer, press the stop button to continue
printing. |
The paper light is on |
No paper is loaded or the loaded paper size does not
match the print setting. Load the correct size paper in the product
and press the stop button to clear the
error. |
The paper light is
flashing |
Paper is jammed in the product or protective material
remains inside. Remove the jammed paper or any protective material
and press the stop button to clear the
error. |
The ink light is on
The paper light is
on |
The product was not turned off correctly. Press the
stop button to clear the
error, then run a nozzle check and cancel any pending print jobs.
Always use the power button to turn off
the product. |
The ink and paper lights are
flashing simultaneously |
The printer cover is open or the output selector is in
the incorrect position. Close the printer cover or change the
output selector's position. |
The ink and paper lights are
flashing alternately |
The maintenance box is at the end of its service life,
not recognized, or installed incorrectly. Replace the maintenance
box or make sure it is installed correctly. |
All lights are flashing |
Paper or protective material is stuck inside the
product. Open the front cover and remove any jammed paper or
protective materials. Turn the product off and then back on again.
If the error continues, contact Epson for support. |
All lights except the power light are
flashing |
An error has occurred during firmware updating. Connect
your product using a USB cable and try updating the firmware again.
If the error continues, contact Epson for support. |