You
need to clean the projector's air filter in the following
situations:
The filter
or vents get dusty.
You see a
message telling you to clean it.
Turn off the projector and unplug the power
cord.
Lift the tab on the bottom of
the air filter cover and pull down to remove the
cover.
Pull the air filter out of the
projector.
Tap each side of the air filter 4 to 5 times
to shake off any excess dust.
Caution:
Do not use excessive force when tapping
the air filter, or it may crack and become unusable. Do not rinse
the air filter in water, or use any detergent or solvent to clean
it. Do not use canned air; the gases may leave a residue, or push
dust and debris into the projector's optics or other sensitive
areas.
Vacuum the front of the air filter (the side
with the tabs) to remove any remaining dust.
Note: If dust
is difficult to remove or the air filter is damaged, replace the
air filter.
Place the air filter back in
the projector as shown.
Attach the air filter cover as shown, and
press it gently until it clicks into place.