Multiple Projector Connection Menu Settings

After connecting multiple projectors to project a unified image, see the tables below to select the correct projector menu settings. Make sure your computer is connected to Projector 1 (the left-most projector in your setup).

Interactive Setup (2 Projectors)



Setting Projector 1 Projector 2
Image Menu
Color Mode Multi-Projection Multi-Projection
Signal I/O Menu
EDID 3240 x 1080/60Hz 3240 x 1080/60Hz
Pen/Touch Menu
Installation of Projectors > Sync of Projectors Wired Wired
Multi-Projection Menu
HDMI Out Setting Process Out Process Out
Order Specify the position of the projectors in number order from left to right
Connect Computer Yes No
Edge Blending > select any edge > Blend Start Position 0 0
Edge Blending > select any edge > Blend Range 600 600
Note: If you are using the projectors in the same room as another projector that does not support multi-projector connections, set the Installation of Projectors > Infrared Intensity setting to Strong.

Non-interactive Setup (2-4 Projectors)



Setting Projector 1 Projectors 2-4
Image Menu
Color Mode Multi-Projection Multi-Projection
Multi-Projection Menu
HDMI Out Setting Pass Through Pass Through
Number of Projectors Specify the number of projectors connected in a series
Order Specify the position of the projectors in number order from left to right
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use