Replacing the Remote Control Batteries

The remote control uses two AAA manganese or alkaline batteries. Replace the batteries as soon as they run out.
Caution:
Use only the type of batteries specified in this manual. Do not install batteries of different types, or mix new and old batteries.
Note: Your remote may look different but the steps are the same.
  1. Remove the battery cover as shown.


  2. Remove the old batteries.
    Warning: If the battery fluid has leaked, wipe it away with a soft cloth and avoid getting the fluid on your hands. If it gets on your hands, wash them immediately to avoid injury.
  3. Insert the batteries with the + and ends facing as shown.
    Warning: Make sure the batteries are inserted in the correct positions. If the batteries are not inserted correctly, they could explode or leak, causing a fire, injury, or damage to the product.
  4. Replace the battery cover and slide it up until it clicks into place.


    Warning: Dispose of used batteries according to local regulations. Do not expose batteries to heat or flame. Keep batteries out of the reach of children; they are choking hazards and are very dangerous if swallowed.
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use