Cleaning Your Product

To keep your product working at its best, you should clean it several times a year.
Caution:
Do not use a hard brush, benzene, alcohol, or paint thinner to clean the product or you may damage it. Do not use oil or other lubricants inside the product or let water get inside it. Close the rear paper feed slot when you are not using it, to keep out dust.
  1. Turn off the product.
  2. Wait for the  power light to turn off, then unplug the power cable.
  3. Disconnect any connected cables.
  4. Remove all the paper from the product.
  5. Clean the outer case and control panel with a soft, dry cloth. Do not use liquid or chemical cleansers.
  6. Clean any paper cassettes using a soft brush.
  7. Clean the scanner glass and the glass area on the left with a soft, lint-free cloth (microfiber is recommended), moistened with a little glass cleaner.
    Caution:
    Do not spray glass cleaner directly on the glass and do not press the glass surface with any force.


    Note: If lines appear on the printout or in scanned images, carefully clean the scanner glass on the left.
  8. Clean the document mat using a soft, lint-free cloth (microfiber is recommended), moistened with a mild detergent.


  9. Wipe the document mat with a clean, dry cloth.
  10. Open the ADF cover.


  11. Use a soft, dry, lint-free cloth (microfiber is recommended) to clean the rollers and the interior of the ADF.


  12. Close the ADF cover.
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use