Loading Long Paper

You can load long paper up to 220 inches (5588 mm) long in the input tray. Some items may require a carrier sheet. Make sure the original meets the specifications before loading it.
  1. Check to make sure that the page separation lever is in the position shown here.

    DS-30000



    DS-32000



    Note: To prevent paper jams, make sure to set the lever back to its original position when scanning standard single- or multi-page originals.
  2. Open the input tray.
  3. Pull out the output tray and its extension, but do not raise the stopper.


  4. Slide the input tray edge guides all the way out.


  5. Load the original in the input tray as shown until it meets resistance.


  6. Slide the edge guides against the edges of the original.


  7. Support the paper at both ends with your hands to prevent it from falling off the ADF, getting jammed, or dropping off the output tray.


Note: You can scan long paper in the following resolutions:
  • Approximately 53 inches (1346 mm) or less: up to 600 dpi
  • Approximately 215 inches (5461 mm) or less: up to 300 dpi
  • Approximately 220 inches (5588 mm) or less: up to 200 dpi
Related references
Suggested Tray Positions
Feed Selector Lever
Original Document Specifications