Accessing Web Config

You can access Web Config from your browser using HTTP or HTTPS.

By default, you access Web Config for the first time using HTTP. If you continue to use HTTP, Web Config will not display all available menus.

  1. Print a network status sheet for your product and identify the product IP address. See the product's User's Guide for instructions.
  2. Start your web browser and make sure JavaScript is enabled.
  3. Type the product IP address into the browser as follows, depending on the protocol you are using:
    • IPv4: http://product IP address
    • IPv6: http://[product IP address]/
    The Status page appears:


  4. To use HTTPS, configure your browser to use HTTPS for the address. A message warning about the self-signed certificate appears.
To access Web Config after configuring HTTPS, enter https:// before the product IP address, shown in step 3.
Note: If the product name is registered with the DNS server, you can use the product name instead of the product IP address to access Web Config.
Was this page helpful? Yes or No.
Privacy Policy | Your California Privacy Rights | Terms of Use