If there is no sound when you expect it or the
volume is too low or high, try the following solutions:
- Adjust the
projector's volume settings.
- Press the
A/V mute button on the
projector remote control to resume video and audio if they were
temporarily stopped.
- Press the
Source button on the projector or the
remote control to switch to the correct input source, if
necessary.
- Check your
computer or video source to make sure the volume is turned up and
the audio output is set for the correct source.
- Check the audio cable connections between the
projector and your video source.
- If you do
not hear sound from an HDMI source, set the connected device to PCM
output.
- Make sure
any connected audio cables are labeled "No Resistance."
- If you are using a Mac and you do not hear sound
from an HDMI source, make sure your Mac supports audio through the
HDMI port. If not, you need to connect an audio cable directly to
your speaker system.
- If you
connected an audio device to the projector's Audio Out port, the internal speaker is
disabled. However, you can still control the volume level via the
projector's control panel or remote control.
- If you
turn the projector on immediately after turning it off, the cooling
fans may run at high speed momentarily and cause an unexpected
noise. This is normal.